metal roof installation for Milwaukee homes, handled by a family roofing company that has been at it since 2002. Estimates are always free.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Milwaukee install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Our metal roof installation work in Milwaukee is handled by crews who do this every week, not by whoever happened to be free that morning. It shows up in the details — valleys, chimney flashing, eave and ridge closures — because that is where roofs actually leak.
We schedule your Milwaukee metal roof installation for a stretch of dry weather, keep the job site picked up as we go, and do not leave a roof open overnight. When it is done the tear off is hauled away and a magnet goes over the drive.
Four steps and no surprises. This is how we have done it since 2002.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
What comes up on just about every estimate for a job like this.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Milwaukee homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Sometimes. If the decking is sound and there is only one layer of shingles, a Milwaukee metal roof can go over the top on purlins. Two layers or rot underneath and we tear off first — and we say so before you sign.
Most Milwaukee metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Installed properly over sound decking, a metal roof should give a Milwaukee home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
Honest words from customers, in their own wording.
"Our church needed a new roof and the budget was tight. They worked with us on it, did beautiful work, and finished before the fall revival."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."